 |
|
|
|
|
|
|
|
|
|
ning
4fiddy Racer
Joined: 13 Feb 2006
Posts: 236
Location: Chch, New Zealand
|
 Posted: Wed Apr 22, 2009 4:46 pm Post subject: Does anyone know what part i need for my yfz450 motor? |
  |
|
ok so i am pretty sure that i lost the bung for my motor while riding. . a lot of oil had spewed out but it still had some left, any way i think that its comming for just above where the header pipe joins the motor in about a 1cm diameter hole which i think should be plugged, here are some very bad pictures to hopefully help you
i need to know what its called so i can get a new one because i cant find any pictures or get hold of anyone
thanks 
[img] [/img]
_________________
Race In Peace Chillibin |
|
| |
|
|
|
|
|
|
|
|
Sponsor
|
|
|
|
|
|
|
|
|
Quad Squad
Blaster class
Joined: 05 Apr 2007
Posts: 193
Location: Melbourne
|
| Posted: Wed Apr 22, 2009 5:16 pm Post subject: |
|
|
Thats the Decomp plug. Its a solid seal to fill in the gallery left by the manual decomp system that was used in previous years, Yamaha must have carried the same casting over.
Your best bet is to get a billet one that is held in by the retaining bolt on the side. That way it will never blow out again
_________________
www.quadsquad.com.au
Follow us on Facebook http://www.facebook.com/atvracetechnology |
|
| |
|
|
|
|
|
|
|
|
ning
4fiddy Racer
Joined: 13 Feb 2006
Posts: 236
Location: Chch, New Zealand
|
| Posted: Wed Apr 22, 2009 6:13 pm Post subject: |
|
|
awesome, thanks so much 
_________________
Race In Peace Chillibin |
|
| |
|
|
|
|
|
|
|
|
PeteW
Moderator
Joined: 09 Feb 2006
Posts: 1877
Location: Doreen, Vic
|
| Posted: Wed Apr 22, 2009 7:33 pm Post subject: |
|
|
what adam said but also I've still got some billet plug that I had made up for the 04 motors and I've possibly even got the seal that you need to go on them too PM me if you want one and I'll post it over.
_________________
www.thumbpump.com
www.dirtcomp.com.au |
|
| |
|
|
|
|
|
|
|
|
bigjon
Moderator
Joined: 17 Feb 2006
Posts: 1279
Location: Dubbo
|
| Posted: Wed Apr 22, 2009 7:59 pm Post subject: |
|
|
When you install the new billet plug, be sure not to over tighten the retaining bolt. It's very easy to strip!
_________________
Don't close your eyes during the crash, you'll miss the best part |
|
| |
|
|
|
|
|
|
|
|
Shawn
Blaster class
Joined: 16 Aug 2008
Posts: 175
Location: Central Coast
|
| Posted: Thu Apr 23, 2009 7:00 pm Post subject: |
|
|
If you need to know what parts are called, try bikebandit.com Just look up your atv,bike,etc and it will have diagrams with all the parts listed.
_________________
Raptor 700R 09' |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
