OZ ATV :: The Australian ATV Forum

[QIKEN]

PURCHASED FATHER AND SON PROJECT GO-kART/ATV,NEW TO THIS TYPE OF ENGINE AND REQUIREMENTS.ANY ADVICE GREATLY APPRECIATED.
HAS LIFAN 110CCC IP52FMH LOCKED IN GEAR ENGINE AND ATV AXLE.
Questions.
I. NEED CDI... IT ONLY HAS A WHITE 4 PIN BLOCK..WIRE COLOR YELLOW,WHITE,BLUE WITH WHITE STRIPE,AND BLACK WITH RED STRIE.
IT ALSO HAS A SEPERATE GREEN WIRE,WITH A ROUND MALE END THAT IS SEPERATE FROM THE BLOCK??? THE GUY SAID I NEEDED A 4 PIN?EVERY ONE SELLS 5 PIN.
2. REQUIRE CARBY..25MM??
3. BATTERY??
4. THE ENGINE DRIVE SHAFT POSITION IS CURRENTLY MOUNTED APPROX 40 DEGREES ANGLE TO THE REAR OF THE AXLE, WILL IT MOUNTED IN THIS POSITION???

[hammer686]

i think these guys are US importers of lifan ya should be able to find info/diagrams on wiring/cdi etc (read footnotes tho)
http://www.hooperimports.com/
driveshaft offset sounds wrong post a pic if ya can
_________________
Raptor 700