 |
 |
OZ ATV :: The Australian ATV Forum
Australia's Largest ATV Forum
|
|
|
|
|
|
|
|
|
|
|
Alexc
50cc nipper
Joined: 29 Sep 2011
Posts: 1
|
 Posted: Thu Sep 29, 2011 4:14 pm Post subject: Suzuki King Quad 750, CV boot between motor and back Diff |
  |
|
Hey guys first post here and also new to quads have my suzuki king quad 750 about 6 months now, and last week i ran into my first "Break"
there are 2 rubber CV Boot looking things on a shaft that goes between the motor and the back diff and i just notice yesterday that one has torn off, I was wondering if anyone could give me a guide on how to replace the boot? Ill upload a photo of the issue.
Any help would be appreciated just need a rough guide and i will use my service manual to hopfully help aswell.
As you can see the closest boot on the shaft is gone almost completely. |
|
| |
|
|
|
|
|
|
|
|
Sponsor
|
|
|
|
|
|
|
|
|
Linc
Roostin Away
Joined: 17 Feb 2006
Posts: 999
|
| Posted: Fri Sep 30, 2011 7:18 pm Post subject: |
|
|
Sorry, cant help but I'm sure these guys could.
www.nyrocatv.com
By far the best Kingquad source on the net.
Linc |
|
| |
|
|
|
|
|
|
|
|
PeteW
Moderator
Joined: 09 Feb 2006
Posts: 1877
Location: Doreen, Vic
|
| Posted: Mon Oct 03, 2011 7:30 pm Post subject: |
|
|
that hard part will be getting the shaft out, after that it is just a simple matter of pulling the joint apart and fitting the new boot.... some CV joints come apart with a clip just inside the main housing and others need to be driven off as they have a clip at the end of the drive shaft inside the CV.
_________________
www.thumbpump.com
www.dirtcomp.com.au |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
© 2001, 2002 phpBB Group
|
|
|
