 |
|
|
|
|
|
|
|
|
|
mxr450
4fiddy Racer
Joined: 23 Feb 2010
Posts: 233
|
 Posted: Mon Dec 20, 2010 8:26 pm Post subject: yfz450r |
  |
|
bike turns over but no fire i think it is the lynyard but not to sure fuel pump is working power comander lights are on air filter just cleaned has any body had a problem on there yfz450r
only thing i can think of is i ran it low on fuel the other the factory gytr lynyard is faulty |
|
| |
|
|
|
|
|
|
|
|
Sponsor
|
|
|
|
|
|
|
|
|
brad0080
Blaster class
Joined: 24 May 2008
Posts: 157
Location: Newcastle
|
| Posted: Tue Dec 21, 2010 12:47 pm Post subject: |
|
|
| Bypass the lanyard. Ya only need to disconnect 2 connectors and join them together. |
|
| |
|
|
|
|
|
|
|
|
brad0080
Blaster class
Joined: 24 May 2008
Posts: 157
Location: Newcastle
|
| Posted: Tue Dec 21, 2010 12:57 pm Post subject: |
|
|
| Replace ya rings and check ya valve clearances. Mine was hard to start and wouldn't idle properly. Found it to be my valves. That was about 6months after I got the bike. |
|
| |
|
|
|
|
|
|
|
|
Noy Q75
Roostin Away
Joined: 16 Nov 2007
Posts: 943
Location: Perth W.A.
|
| Posted: Tue Dec 21, 2010 2:43 pm Post subject: |
|
|
When you turn your key on you should hear the fuel pump prime up and a issue a few of us have had with them not starting is the engine kill switch .. push your start button on and hold it on and play with the red kill switch on top of it we have had a few of these get dirt and the bike wont go so just flik it off and on and see what that dose 
_________________
Sponsors ,Cullys Yamaha,Pirtek Malaga
2x YFZ 450r "09" 2x 90 Raptor "09"2x 125Raptors "12"
N# 1 Aus Quad Nats Vets 2010
N# 1 at BSA-HD for 09,10,11
N# 2 W.A. State Clubman A 2010
N# 3 W.A. State Vets 2011
N# 1 W.A. State Vets 2012 |
|
| |
|
|
|
|
|
|
|
|
mxr450
4fiddy Racer
Joined: 23 Feb 2010
Posts: 233
|
| Posted: Tue Dec 21, 2010 3:18 pm Post subject: yfz450r |
|
|
problem sorted removed the gytr lanyard cleand the connecters and changed the plug starts fine now
thank you for your feed back
has any body had problems with there gytr lanyard the one on my bike keeps going when u pull the pin out and doesnt cut out until you play with the wires going into it
pretty sure a new pro armour one will fix the problem
GYTR should be GNTR (gona need to'b replaced) |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
