OZ ATV :: The Australian ATV Forum

[HST Powersports]

hey anyone had probs with jettin before?

My Banshee has major port work barrels 1 size over. Standard head worked T5 toomey pipes K&N pod filter in box was running air box lid standard pilot dynojet needle 280 main. standard reeds and standard carbs all workin ok prior to removing old carbs as they leaked dirt into top of slide. now i have purchased a set of 28mm mikuni flat slides and got big dramas wont rev had air box lid on for ride day at singleton not good cant find any specs on carbs tied 280 mains standard pilot and needle set middle no good flooding itself trying 300 mains standard pilot 25 needle set the same with airbox lid off to see how it goes. Noone in australia including importers (Mikuni OZ) cant even give me any Specs or diagrams..... anyone dealt witht these carbs before and have any info on them.....please reply hoping to run in QLD for race on 25th nov with Mick Roycroft

[greenhuman]

If where you got them don't have a clue on how to set them up or advise you sensibly, take them back, then get a set of 28 PWK style carbs and only then you will be OK to go. I will try to get some info for you, but those Mikuni's are a MoFo to set up properly.

[PeteW]

for one I agree with john, get some keihins, much easier to get sorted.
_________________


www.thumbpump.com
www.dirtcomp.com.au

[HST Powersports]

the mikunis go well just need to fine tune them started listening to my good m8 hollywood lol should have listened to him in the first place. almost got it running good just fine tuning it now any one out there who has played with the mikuni 28mm flat slides help and information would be helpful.....