 |
|
|
|
|
|
|
|
|
|
SXS Machine Racing Team
Roostin Away
Joined: 29 Nov 2007
Posts: 879
|
 Posted: Tue Jun 17, 2008 3:51 pm Post subject: Wanted: Banshee complete roller - no longer needed |
  |
|
Engine bay size is critical to fit non-std quad engine so somthing with tight tolerances for a single will not do, but a single with plenty of room in front will be good.
Best in case would be bike previously built for X country racing, so shocked, spaced and swingarm legnth appropriate.
Is for a concept bike so think built down to a price (by an invalid pensioner! $$) not built up to a spec.
Prefer local so can inspect.
PM's?e-mails only.
_________________
www.asho.com.au for your shooting and outdoor needs
www.paracordaustralia.com - all things Paracord for outdoor adventure and craft
Tweet - ceo@futrixenterprises.com.au
Last edited by SXS Machine Racing Team on Tue Jun 24, 2008 4:36 pm; edited 1 time in total |
|
| |
|
|
|
|
|
|
|
|
Sponsor
|
|
|
|
|
|
|
|
|
SXS Machine Racing Team
Roostin Away
Joined: 29 Nov 2007
Posts: 879
|
|
| |
|
|
|
|
|
|
|
|
4wheelfury
50cc nipper
Joined: 08 May 2008
Posts: 13
|
| Posted: Fri Jun 20, 2008 10:35 am Post subject: |
|
|
Hey Geeman have you seen this thread :-
http://www.ozatv.com/forum/viewtopic.php?t=6233
If so sorry to waste your time. Just i know how hard it can be to find what your looking for without a hand. |
|
| |
|
|
|
|
|
|
|
|
SXS Machine Racing Team
Roostin Away
Joined: 29 Nov 2007
Posts: 879
|
| Posted: Fri Jun 20, 2008 11:58 am Post subject: |
|
|
Nah tHats OK
Thanks for keeping an eye out for me, appreciated it is: says yoda.
Have been talking to Ashe since my initial post, so great minds think alike.
Regards
Gavin
_________________
www.asho.com.au for your shooting and outdoor needs
www.paracordaustralia.com - all things Paracord for outdoor adventure and craft
Tweet - ceo@futrixenterprises.com.au |
|
| |
|
|
|
|
|
|
|
|
SXS Machine Racing Team
Roostin Away
Joined: 29 Nov 2007
Posts: 879
|
| Posted: Tue Jun 24, 2008 4:35 pm Post subject: |
|
|
No longer needed!!
Engine rooted and mislead by wrecker to think it was a goer.
> hi,went to look at engine , will only suit spares as crankcase is broken andclutch is missing, but will keep an eye out for any others regards tony
>> Tony>> Just a reminder to take some photo's of the bike.>> Looking at>> engine,> full electrics> instrumentation>> for the $1000>> I think I'll be accepting at this point there is no radiator left.>> Please do a couple of measurements for me too.>> Length from chain casing to front part of motor and what that is (expect> its front cylinder)> Height from bottom sump to top of BOTH pistons. (or if carbs or efi is> sitting on top whatever heights motor point is.)> And top of each piston to rear casing at bottom.>> Just to check fit initially. I'll probably double check that prior to> purchase if alls good.>> Thanks and appreciation>> Gavin>
_________________
www.asho.com.au for your shooting and outdoor needs
www.paracordaustralia.com - all things Paracord for outdoor adventure and craft
Tweet - ceo@futrixenterprises.com.au |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
