 |
|
|
|
|
|
|
|
|
|
450yam
Blaster class
Joined: 13 Jun 2006
Posts: 105
|
 Posted: Mon Jul 10, 2006 8:03 pm Post subject: caster |
  |
|
I figure it is easier to set the caster with a straight edge rather than a angle finder so....
If setting caster with a straight edge how many mm offset should there be between ball joint spindles???? |
|
| |
|
|
|
|
|
|
|
|
Sponsor
|
|
|
|
|
|
|
|
|
REDTED
Roostin Away
Joined: 15 Jun 2006
Posts: 627
Location: Orange N.S.W
|
| Posted: Wed Jul 12, 2006 8:11 pm Post subject: Castor????????? |
|
|
Set it with youre angle finder & then mesure it with a straight edge OR set it so it steers straight,not too heavy or light.
_________________
Cheers-Redted. 04 Raptor |
|
| |
|
|
|
|
|
|
|
|
PeteW
Moderator
Joined: 09 Feb 2006
Posts: 1877
Location: Doreen, Vic
|
| Posted: Fri Jul 14, 2006 12:21 am Post subject: |
|
|
ahhh a challenge. I shall go measure tomorrow.
I usually just use the angle finder though.
_________________
www.thumbpump.com
www.dirtcomp.com.au |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
