Dustjunkie
50cc nipper
Joined: 04 May 2010
Posts: 2
Location: Bangalow, NSW
 |
 Posted: Wed May 05, 2010 6:01 pm Post subject: Separating engine from transmission - shaft drive |
  |
|
| Can anyone tell me how I go about splitting the engine from the drive shaft on a YFM200DX? I have removed the boot from the top end and taken out the 4 bolts holding what I assume is the bearing plate but nothing seems to want to budge. My next step would be to remove the clutch/gearbox housing to see how it's connected inside but don't want to do this unless absolutely necessary. Any help or ideas greatly appreciated....... |
|
