OZ ATV :: The Australian ATV Forum Forum Index OZ ATV :: The Australian ATV Forum
Australia's Largest ATV Forum

FAQFAQ
SearchSearch
MemberlistMemberlist
UsergroupsUsergroups
Sign up!Sign up!
My ProfileMy Profile
Log in to check your private messagesLog in to check your private messages
Log inLog in

Brake caliper on a FL250 Honda Oddyessey
Post new topic Reply to topic OZ ATV :: The Australian ATV Forum Forum Index -> Technical
View previous topic :: View next topic
CHATRUSE
50cc nipper


Joined: 30 May 2009
Posts: 3
Location: Sydney
PostPosted: Wed Dec 09, 2009 1:32 pm Post subject: Brake caliper on a FL250 Honda Oddyessey Reply with quote Back to top
Hi all, im currently rebuilding a FL250 Honda Odyssey and have struck a little problem. Im only a amatuer and its my first odyssey. I seem to have a problem with fitting the brake caliper in place. I expand the gap between the pads & bolt it all in place but the pads seem to always close up locking up hard against the disk. I tried releasing the tension in the brake cable but same issue. Are there any steps that i should follow or something that the manual does not state that i should be doing? Thanks.
 
View user's profile Send private message
Sponsor
Display posts from previous:
Post new topic Reply to topic OZ ATV :: The Australian ATV Forum Forum Index -> Technical All times are GMT + 10 Hours
Page 1 of 1


Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
© 2001, 2002 phpBB Group

OZATV.com managed by KPS