 |
|
|
|
|
|
|
|
|
|
robbo350
50cc nipper
Joined: 09 Dec 2008
Posts: 8
Location: perth
|
 Posted: Sat Jan 31, 2009 3:30 pm Post subject: splitting banshee engine cases |
  |
|
hey guys im splitting my cases to change all the seal etc...how hard is it and can anyone tell/warn me about anything i need to know or check?
cheers
_________________
98 model banshee runnin-fmf gold series fattys
k&n filter, k&n powerlid,boysen reeds with spacer,razor2 tyres at rear,razors up front,nerfs |
|
| |
|
|
|
|
|
|
|
|
Sponsor
|
|
|
|
|
|
|
|
|
1sick6
Big Bore, Stroked & Bling +
Joined: 20 Dec 2006
Posts: 340
Location: SA
|
|
| |
|
|
|
|
|
|
|
|
bansheebuzz
4fiddy Racer
Joined: 07 Aug 2007
Posts: 255
Location: Gold Coast
|
| Posted: Sun Feb 01, 2009 5:45 pm Post subject: |
|
|
this is one of the easy motors to split the cases. The top case lifts off and the box and crank lay in the lower half. Just take good note when your pulling everything out to make sure it goes back together right. If you pull the box and selector forks out take extra care that everything is right
_________________
Queensland Quad Riders Association
www.qldqra.com |
|
| |
|
|
|
|
|
|
|
|
4stroker
Joined: 15 Jan 2007
Posts: 1420
Location: North Queensland
|
| Posted: Mon Feb 02, 2009 8:26 am Post subject: |
|
|
make sure you take off the bearing retainer plate behind the clutch basket it bolts to the bottom and top case halves.
oh yeah and use the proper flywheel puller or you'll damage the flywheel!
piece of cake otherwise.
_________________
2002 SE Banshee |
|
| |
|
|
|
|
|
|
|
|
Hulk
Big Bore, Stroked & Bling +
Joined: 16 May 2007
Posts: 432
Location: Sydney
|
| Posted: Mon Feb 02, 2009 8:20 pm Post subject: |
|
|
what 4 stroker said..... | Quote: | oh yeah and use the proper flywheel puller or you'll damage the flywheel!
|
and that will be the hardest bit i think  |
|
| |
|
|
|
|
|
|
|
|
4stroker
Joined: 15 Jan 2007
Posts: 1420
Location: North Queensland
|
| Posted: Tue Feb 03, 2009 8:47 am Post subject: |
|
|
yeah if the flywheel hasnt ever been off it'll prob be a pain in the arse. we broke the puller tryin to get one off once, had to drill and tap the female part of the puller to take a bigger bolt to get the job done.
might have to (carefully) use a bit of heat to coax it off.
_________________
2002 SE Banshee |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
